Punch and Die Work e-bog

Whilst the greatest effort has been made to ensure the quality of this text, due to the historical nature of this content, in some rare cases there may be minor issues with legibility. A third method consists in making a shoe having the back of the slot planed at the angle mentioned, while the front wall is made square with the bottom, the die being held with setscrews, as shown in Fig. 4. If this form is used, care must be exercised when laying out the screw holes, so that they do not come in line with the screws in the bolster when the shoe is in its proper place; and, again, the screws must not press on any portion of the die immediately in line with the opening, or it will be closed somewhat when pressure is applied to the screws. Fig. 4 shows the screws pressing on the solid portion of the die.